Lighting Headlight, Side Marker, Park & Turn Signal Assembly Removal & Installation To Remove: Be careful not to bend, break or damage the clip or the bulb.Д¦.) Insert the replacement bulb into the headlight socket and reattach the metal clip that holds the bulb in place.Д§.) Relatch the plastic clip holding the headlight assembly case in place.ДЁ.) Reconnect the electrical connection to the back of the headlight assembly.Д©.) Replace the radiator overflow bottle or the battery, depending on which bulb you replaced. This will be a bundle of wires with a wide plug sticking into the back of the assembly.Д¤.) Unlatch the plastic clip holding the headlight assembly case in place.ДҐ.) Pry the small metal clip holding the bulb using your fingers or a screwdriver. You will do this by unscrewing the positive (red) and negative (black) terminals that connect the battery to the engine, and then lifting the battery straight out of its housing.ДЈ.) Remove the electrical connection on the back of each headlight assembly. If you are replacing the driver's side bulb, you may need to remove the battery.

The bottle will unhook from its connective tube by pulling it toward the front of the car and up from the ground. If you are replacing the passenger side bulb, you will need to remove the radiator overflow bottle. The headlight assemblies are only accessible from the engine compartment.Дў.) Clear the area behind the bulb you are replacing.

2010 pontiac vibe